Max1 front light E-bike 40

Max1 front light E-bike 40

Powerful MAX1 E-bike 40 light.

Description:

• Easy mounting on the fork

• Made of ABS and a polycarbonate reflector.

• Clean, minimalist size with outstanding brightness of 40 lux.

• Works with any DC power source of 6 V - 48 V and is supplied with a robust fork mount.

• E-bike 40 front light ready for easy installation on any e-bike system, Bosch, Shimano, Sport Drive and others

Technical parameters:

• Effective illumination intensity is greater than 40 lux / 250 lm.

• An LED chipset with an effective output of 3 W is used as the light source.

• The light can be powered from any DC source with a voltage of 6 - 48 V.

• Recommended power supply: connect to the e-bike battery, e.g. via a USB connector, a Bosch connector or directly to the terminal block of the e-bike motor or battery.

• The connector is not included with the light. The light has no switch of its own. It is intended for e-bikes with light control from a handlebar controller, or it must be retrofitted with a separate switch.

• The light was developed especially for e-bikes, but that is not a requirement.

• It can be connected to any source with a voltage of 6 to 48 V, and also to a dynamo.

• 100% water-resistant - IP66 standard.

• Use: for mounting on the front fork of an e-bike – the mount is included with the light.

• Integrated reflector, which can be removed.

• Weight: 53 g

Mounting:

• The light is intended to be mounted by a professional service.

• The light should be installed 400 to 1 200 mm above the road and set so that the centre of the light cone at a distance of 5 m is at half the height of the upper edge of the reflector.

• The delivery includes the light, a 2× 140 cm stranded cable without a connector, and a metal mount for the fork crown.

• For mounting on the front fork of an e-bike, use only the supplied mount. Tighten the screws properly to prevent the light from loosening accidentally.

• Wiring: connect + (plus) to the black-white wire and - (minus) to the black one.

• If you connect the light the wrong way round, it has protection - you will not destroy it, it just will not light.

Note:

If you have an e-bike with a Bosch drive and the bike was already equipped with an ordinary light installed at the factory, we recommend contacting a Bosch service centre. The new light output setting of the system must be configured and activated before the Bosch e-bike will recognise and power this new light.